Home News & Blog Plastics Manufacturing The Industries We Work With

The Industries We Work With

Plastic is everywhere. If you are reading this, then you are either in direct contact with plastic right now or likely very close to lots of it. That’s because plastic is in almost every single electronic device, from your computer to your smart phone to your refrigerator, car, and especially in the airplanes flying overhead.

Here at Tru-Form Plastics, we are sometimes asked what industries we specialize in. The real answer is that we specialize in plastic. If your industry uses plastic, then we can help you. Since we haven’t discovered an industry that doesn’t use plastic in some form or another, then in reality, we specialize in all industries.

However, we have direct experience in these industries:

  • Medical
  • Aerospace
  • Communications
  • Electronics
  • OEM Components
  • Consumer Products
  • Point of Purchase
  • Appliances
  • Marine
  • Agriculture
  • Automotive

Of course, this is only the beginning of our core competency. If you are looking for plastic parts, regardless of your industry, give us a call. We’re sure we can help you!

Recent Articles

  • Design for Manufacturability in Thermoforming: What Engineers Need to Know

    At Tru-Form Plastics, we believe successful thermoforming projects start well before a part reaches production. Bringing manufacturing expertise into the design process early can help customers avoid problems, find better ways to achieve their goals, and make informed decisions about materials, geometry, tooling, and assembly. Whether we’re developing a creative solution with an engineering team…

    Read More

  • Solving a Complex Assembly Challenge with an Aircraft Lavatory – Toilet Shroud

    The aircraft lavatory toilet shroud presented a problem that many thermoformers would not want to touch. The existing manufacturing method relied on drape forming, a labor-intensive process that required multiple people to handle and shape heated plastic by hand. It was slow, difficult to control, and not well-suited for repeatable production. For the customer, that…

    Read More

  • Nearshoring vs. Onshoring: Choosing the Right Manufacturing Strategy for Aerospace and Defense

    A prototype needing another revision on Thursday creates a different sourcing problem than a production part that has run unchanged for three years. Aerospace and defense OEMs source both types of work, which is why the nearshoring vs. onshoring question rarely has one answer. Mexico offers real geographic and cost advantages; domestic production brings something…

    Read More